Page 1 of 1
Oceanic Datapro plus 2.1
Posted: Wed Sep 03, 2014 9:13 pm
by PapaZ
oceanic datamax pro plus 2.1, how do you make the display show 'Time Remaining before reaching the No Decompression limit?'
Display shows air time remaining based upon the current consumption rate or it will show deco time IF YOU go into deco.
Re: Oceanic Datapro plus 2.1
Posted: Wed Sep 03, 2014 9:36 pm
by kdupreez
It displays Air Time Remaining
OR No-Deco Time Remaining as single "Dive Time Remaining" value and it picks the one that allows less time..
Check out "Dive Time Remaining" on Page 11 of your computer's manual..
You can also download it here:
http://www.oceanicworldwide.com/us/medi ... 28-r05.pdf
Re: Oceanic Datapro plus 2.1
Posted: Thu Sep 04, 2014 10:40 am
by PapaZ
Yes, I have read that. Thank you.
Would like to find a way to have it always show 'time remaining until going into deco'.
Re: Oceanic Datapro plus 2.1
Posted: Thu Sep 04, 2014 11:03 am
by CaptnJack
PapaZ wrote:Yes, I have read that. Thank you.
Would like to find a way to have it always show 'time remaining until going into deco'.
Even if you run out of gas first?
Wait nevermind, being related to MZ I imagine you never run out of gas
Re: Oceanic Datapro plus 2.1
Posted: Thu Sep 04, 2014 12:57 pm
by Desert Diver
You would have to run fast to give me a computer that tried to determine when I was going to run out of air!
Re: Oceanic Datapro plus 2.1
Posted: Tue Sep 16, 2014 3:05 pm
by dwinslow1
Call Oceanic tech support, they can tell you if that is possible.