Argon Cylinder Mounting
-
- Frequent Bubbler
- Posts: 39
- Joined: Mon Aug 08, 2011 12:32 pm
Argon Cylinder Mounting
How are divers mounting their argon cylinders? Size and location. Mounting cylinder to side of plate, waist belt, back cylinder(s) or a add on drysuit pocket.
Re: Argon Cylinder Mounting
6cuft on the plate with 2" webbing and bungee mount.
"Screw "annual" service,... I get them serviced when they break." - CaptnJack (paraphrased)
"you do realize you're supposed to mix the with water and drink it, not snort the powder directly from the packet, right? " - Spatman
"you do realize you're supposed to mix the with water and drink it, not snort the powder directly from the packet, right? " - Spatman
Re: Argon Cylinder Mounting
+1Nwbrewer wrote:6cuft on the plate with 2" webbing and bungee mount.
...I like going to the chamber.. They have great food there, and awsome live music "H20doctor"
Check out the VIDEOS!
Check out the VIDEOS!
Re: Argon Cylinder Mounting
I'm assuming there's some awesome nwbrewer diy mount, right?
I'm going to look like a moose on rollerskates. -airsix
... my Mom caught me fenestrating once. -lavachickie
And I get so tired of fainting and peeing all over myself when the hammer falls on an empty chamber! -Nailer
Want to know where I'm performing? Check out my Facebook fan page!
... my Mom caught me fenestrating once. -lavachickie
And I get so tired of fainting and peeing all over myself when the hammer falls on an empty chamber! -Nailer
Want to know where I'm performing? Check out my Facebook fan page!
Re: Argon Cylinder Mounting
Of course, but it's more or less the standard UTD mount. I just cut the 2" webbing and added some bungee to keep it tight to the plate.scottsax wrote:I'm assuming there's some awesome nwbrewer diy mount, right?
"Screw "annual" service,... I get them serviced when they break." - CaptnJack (paraphrased)
"you do realize you're supposed to mix the with water and drink it, not snort the powder directly from the packet, right? " - Spatman
"you do realize you're supposed to mix the with water and drink it, not snort the powder directly from the packet, right? " - Spatman
Re: Argon Cylinder Mounting
an even quicker DYI mount is thicker bungee loop with a knot, slip the loop through the BP sex-bolt hole in the middle-left, so the knot keeps the bungee in place and loop it over the 6cft argon, then a thinner bungee at the bottom of the BP that hooks over the valve/reg.. its a pretty elegant solution and the bottle aint goin nowhere.. I did this for a few people "on site" and its pretty portable too..
2 pieces of bungee.. doesnt get simplier, cheaper and easier.
the more "official" config is a piece of webbing (I used a thick bungee here instead of the webbing) and a thin bungee at the bottom.. kinda looks like this:
2 pieces of bungee.. doesnt get simplier, cheaper and easier.
the more "official" config is a piece of webbing (I used a thick bungee here instead of the webbing) and a thin bungee at the bottom.. kinda looks like this:
"I believe that if life gives you lemons, you should make lemonade... And try to find somebody whose life has given them vodka, and have a party" - Ron White